Introduction:

Airflow charcoal making machine, which adopts advanced hot flue carbonizing technology, is one of our latest developed products. Modern-designed airflow charcoal making machine greatly increases carbonizing ratio from about 88% to 99%, and shortens carbonizing time (from 24 to 6 hours). Also this airflow charcoal making machine is characterized by easy operation, safety, efficiency, energy saving and environment protection.Inner pots of airflow charcoal making machine for charcoal production can be hanged outside, which will save a lot of cooling time, so the productivity increases greatly. It is the ideal choice for charcoal production plant.

The new environmentally friendly horizontal airflow carbonization furnace adds a flue gas recovery device on the basis of the original carbonization furnace. After the flue gas is recovered, it can be dust-free and smoke-free. The recovered flue gas can be ignited like liquefied gas for heating, cooking, and Dryer use. At present, there are three types of carbonization furnaces, common type (can only be used to produce charcoal, not to collect gas); wood carbonization equipment (used to carbonize branches, wood blocks, coconut shell blocks, scrap pieces in furniture factories, etc.) This equipment can be configured The gas recovered by the gasification furnace device can be turned into fuel gas for the carbonization furnace's own use or other); the new horizontal environmentally friendly carbonization furnace has the effect of one machine and two purposes, and the materials can also be directly carbonized, or can be carbonized after rods.

To improve the design of the charcoal carbonization furnace, in order to prevent gas leakage, the oven door with graphite packing seal, greatly enhancing the effect of carbonization

In the carbonization process ,can produce combustible gas,can recycle these gas.These gas delivery to the white tank through No.1 pipeline,then open the valve of the No.2 pipeline, these gas can reach to the bottom of the furnace through the No.2 pipeline.At the No.4 valve, you can be connected to a pipeline at the No.4 valve, so that can use the extra gas,these gas can cooking, burnning boiler etc.So can save some cost, it is energy saving.

This is shunt tank, at the Nbottom(NO.5) can collect the wood tar.

Raw Materials:

Sawdust, Crops Straw(corn stalk, beanstalk, broomcorn stalk, cotton stalk, rape stalk,palm kernel shell, groundnut stem, sunflower stalk), Husk, Grass, Bush branches, Bamboo butt, Bamboo scraps, Bagasse and so on.

The whole line of making wood briquette charcoal
1.Crush the raw material into small pieces (diameter is about 3-5mm);
2.Dry the material by machine or dried it in the sun , till the moisture is less than 12%;
3.Put the material into feed let of briquette machine;
4.Produce the briquette stick from biomass material without any additive;
5.Carbonized the briquette stick.